If you want to invest in new fascia decking boards, but want them to look good and last for years, then it’s worth looking into this step-by-step guide. You will learn how to install fascia decking boards for a board and create an attractive feature that will add value to your home. This guide is prepared after consulting many experts like Brite Decking.
Measure the space you have to work with
Measure the width and height of the space (including any trim)
Measure how deep you want your fascia board to go, including any trim or molding that may be around it. This will help ensure that there is enough room for installation and no gaps between boards once installed.
Cut all boards to size
Cut all boards to size. Use a power tool to cut the boards, such as a miter saw or circular saw. Make sure you use a straight edge to guide the saw and make sure that the blade is sharp enough to cut through your fascia board without gouging it.
Use an electric miter saw with an adjustable tilt-angle table (adjustable length of cut) on top of which you can place your fascia board at any angle desired. Use this technique for cutting corners as well as straight edges in order to ensure even results throughout your project
Install the first board, leaving a small gap between the board and the wall
Measure the gap between the wall and the board with a tape measure. This is the distance you want to leave between your fascia and your wall, so make sure it’s wide enough for your decking boards to fit in.
Cut out a piece of wood that matches this measurement (you can use an old door as a template).
Place it against one side of your wall and mark where it stops with a pencil or marker—this will be where you need to drill holes for screws later on.4
Leave equal gaps between all other boards
You should leave equal gaps between all other boards, as well as the fascia board. The most important thing is to make sure that your gaps are the same size on both sides of the board. This will ensure that no water can seep through between them and damage your wood.
Leave a gap at the front of the fascia, then trim
To cut the fascia boards at an angle, you’ll need to use a jigsaw and a template. The jigsaw should be set up so that it cuts at an angle of 45 degrees. You can use your router and template to make this cut as well, but the jigsaw will be faster and easier if you don’t have access to power tools.
It is easy to fit fascia decking boards, just make sure you get accurate measurements and leave a front gap.
Get the tools and materials you need.
Measure your space accurately, then leave a small gap between the fascia boards and the wall.
Leave equal gaps between all other boards in order to get an even finish on all sides of your fascia board installation.
Leave a gap at the front of your fascia board, then trim down any excess material with a saw or circular saw that has been fitted with a coping disk (a thin shim).
Conclusion
It is easy to install fascia decking boards, just make sure you get accurate measurements and leave a front gap. If you follow these instructions it will be well worth your time! Read More – Why is Australian Sir Walter Turf So Popular?
fascia decking boards. Cut all boards to size. Use a power tool to cut the boards, such as a miter saw or circular saw. Make sure you use a straight edge to guide the saw and make sure that the blade is sharp enough to cut through your fascia board without gouging it. Source Wikimedia
